Fan Switch Sub-Harness for K-Swap

Looking to run a Fan Switch on your K-Swapped Honda? 

We have the solution for you!

For a clean install, simply plug our harness into your fan switch using the pre-wired connector

On your connector you have two wires - one is a 30cm earth strap to be connected a suitable ground point on your chassis, the other is 200cm in length and covered in a black braided sleeving for a high quality finish in your engine bay, this is ran to your conversion harness inside your cabin.

If using our K20a engine harness, you can run this wire through our custom bulkhead plate.